Cisco RJ-45-to-AUX - Using the Show Vlan Command on a Set;Clear Command−Based IOS; Using the Show Vlan Command on a Cli−Based IOS

Ethernet 0/9, Ethernet 0/10, Ethernet 0/11, Ethernet 0/12
Ethernet 0/25, FastEthernet 0/26, FastEthernet 0/27
1912EN#show port monitor
Port monitoring state: Enabled
Monitor port: None
Ports being monitored:
Ethernet 0/1
1912EN#show port system
Switching mode: FragmentFree
Use of store and forward for multicast: Enabled
Network port: Ethernet 0/8
Half duplex backpressure (10 Mbps ports): Disabled
Enhanced Congestion Control (10 Mbps ports): Disabled
Default port LED display mode: Port Status
1912EN#
Using the show vlan Command on a Set/Clear Command−Based
IOS
You can use the show vlan command on a Set/Clear command−based IOS switch to obtain configuration
information and protocol statistics for each VLAN. Let’s look at the command, its optional syntaxes, and an
example of its output:
show vlan [vlan] [trunk|notrunk]
Catalyst5002> show vlan
Virtual LAN ID: 1
vLAN Trunk Interface: FastEthernet1/0.1
Protocols Configured: Address: Received: Transmitted:
IP 68.127.187.10 95563219847 81294682
Virtual LAN ID: 2 (Inter Switch Link Encapsulation)
vLAN Trunk Interface: FastEthernet1/0.2
Protocols Configured: Address: Received: Transmitted:
IP 68.127.186.1 855147 854281
Catalyst5002>
Using the show vlan Command on a CLI−Based IOS
You can use the show vlan command on a CLI−based IOS switch to obtain configuration information for
each VLAN. Let’s look at the command, its optional syntaxes, and an example of its output:
show vlan <vlan>
1912EN#show vlan
VLAN Name Status Ports
————————————————————————————————————
334