Cisco RJ-45-to-AUX - Verifying the VTP Configuration on a Set;Clear CLI; Displaying VTP Statistics

1900EN(config)#vtp domain Coriolis
1900EN(config)#
To set a VTP domain password on a 1900EN to “pass1” use the following command:
1900EN(config)# vtp password pass1
1900EN(config)#
Verifying the VTP Configuration on a Set/Clear CLI
To verify the VTP domain information, use the command show vtp domain. This command will show you
the domain name, mode, and pruning information:
5002> (enable) show vtp domain
Domain Name Domain Index VTP Version Local Mode Password
——————————————— ———————————— ————————— ———————— —————————
Coriolis 1 2 server −
Vlan−count Max−vlan−storage Config Revision Notifications
—————————— ———————————————— ——————————————— ——————————————
2 1023 1 disabled
Last Updater V2 Mode Pruning PruneEligible on Vlans
———————————— ———————— ——————— ———————————————————————
130.10.10.14 enabled disabled 2−1000
Console> (enable)
Warning You cannot use the show vtp domain command on a 1900. You should use the show vtp
statistics command instead.
Displaying VTP Statistics
The show vtp statistics command shows a summary of the VTP advertisement messages that have been sent
and received, as well as errors. The command is the same on the Set/Clear and Cisco CLI switches.
5002> (enable) show vtp statistics
VTP statistics:
summary advts received 0
subset advts received 0
request advts received 0
summary advts transmitted 5
subset advts transmitted 2
request advts transmitted 0
No of config revision errors 0
No of config digest errors 0
VTP pruning statistics:
Trunk Join Transmitted Join Received Summary advts received from
non−pruning−capable device
——————— ———————————————— ————————————— ——————————————————————————
2/12 0 0 0
5000> (enable)
1912EN#sh vtp stat
Receive Statistics Transmit Statistics
———————————————————————————— —————————————————————————————
Summary Adverts 0 Summary Adverts 0
Subset Adverts 0 Subset Adverts 0
Advert Requests 0 Advert Requests 56
Configuration Errors:
Revision Errors 0
111