Receive Statistics Transmit Statistics
—————————————————————————————————— —————————————————————————————————
Total good frames 2504 Total frames 11745
Total octets 242467 Total octets 875657
Broadcast/multicast frames 359 Broadcast/multicast frames 11745
Broadcast/multicast octets 105187 Broadcast/multicast octets 875657
Good frames forwarded 360 Deferrals 0
Frames filtered 2144 Single collisions 0
Runt frames 0 Multiple collisions 0
No buffer discards 0 Excessive collisions 0
Queue full discards 0
Errors: Errors:
FCS errors 0 Late collisions 0
Alignment errors 0 Excessive deferrals 0
Giant frames 0 Jabber errors 0
Address violations 0 Other transmit errors 0
1912EN#
Using the show log Command on a Set/Clear Command−Based
IOS
On the Set/Clear command−based IOS, you can view the stored logs by using the show log command. Let’s
look at the command, its optional syntax, and an example of its output:
show log [module number]
Catalyst5002> (enable) show log
Network Management Processor (ACTIVE NMP) Log:
Reset count: 1
Re−boot History: Aug 04 2000 23:06:05 0
Bootrom Checksum Failures: 0
UART Failures: 0
Flash Checksum Failures: 0
Flash Program Failures: 0
Power Supply 1 Failures: 1
Power Supply 2 Failures: 0
Swapped to CLKA: 0
Swapped to CLKB: 0
Swapped to Processor 1: 0
Swapped to Processor 2: 0
DRAM Failures: 0
Exceptions: 1
Last Exception occurred on …
Software version = 4.1
Error Msg:
PID = 0 Kernel
PC: 10000D0C, Status: 2704, Vector: 007C
sp+00: 14041000 0D0C007C 2604101F 0D3A00AC
sp+10: 00000000 101785A2 00000030 102FB12C
sp+20: 10FFFF9C 10179C06 10357A90 102FB12C
sp+30: 10FFFFA8 101FB86E 00000000 10FFFFE8
sp+40: 101FC0D4 00000000 10278814 00002000
sp+50: 00000080 0000101F B9862078 01000001
sp+60: 1CD80000 001E0000 00010000 00000000
sp+70: 00000000 00000000 00000007 68000000
sp+80: 00000000 00000000 00000000 00000000
sp+90: 00000000 103FFFEC 10000420 100009C2
sp+A0: 10000940 10000A4E 10001030 10001030
336
To Next Page
Loading...
