Cisco RJ-45-to-AUX - Displaying Rgmp−Capable Router Ports; Displaying RGMP VLAN Statistics; Configuring GMRP

To display the total number of RGMP groups, use the following command:
Coriolis> (enable) show rgmp group count [vlan]
Total Number of Entries = 2
Displaying RGMP−Capable Router Ports
To display the ports to which RGMP routers are connected, use the following command:
Coriolis> (enable) show multicast router rgmp
PortVlan
—————————
2/1 +1
2/16 +2
Total Number of Entries = 2
‘*’ − Configured
Displaying RGMP VLAN Statistics
To display RGMP statistics, use the following command:
Coriolis> (enable) show rgmp statistics 1
RGMP enabled
RGMP statistics for vlan <1>:
Receive:
Valid pkts:10
Hellos:5
Joins:3
Leaves:2
Byes:0
Discarded:0
Transmit:
Total Pkts:10
Failures:0
Hellos:10
Joins:
Leaves:0
Byes:0
You can reset the statistics with the command clear rgmp statistics.
Configuring GMRP
To enable GMRP globally, use the following command:
Coriolis> (enable) set gmrp enable
GMRP enabled.
156