Cisco RJ-45-to-AUX - Setting the Boot Config−Register on the Supervisor Engine Module

Configure the password for Enable mode. Press Enter for the old password if none has ever been
configured:
Catalyst5000> (enable) set enablepass
Enter old password:
Enter new password: coriolis2
Retype new password: coriolis2
Password changed.
Catalyst5000(enable)
4.
Enter the IP address and the default gateway (router) for the switch on the Supervisor Engine module
SC0:
Catalyst5000> (enable) set interface sc0 63.78.39.174 255.255.255.0
Interface sc0 IP address and netmask set.
Catalyst5000>(enable) set ip route default 38.68.127.254
Route added.
5.
Enable trunking on interface 2/2 to complete your trunk link to the 1912EN switch and on interface
2/24 to the router for interVLAN routing:
Catalyst5000> (enable) set trunk 2/2 mode on isl
Port(s) 2/2 trunk mode set to on.
Port(s) 2/2 trunk type set to isl.
2000 Nov 19 12:31:54 %DTP−5−TRUNKPORTON:Port 2/2
Catalyst5000> (enable) set trunk 2/24 mode on isl
Port(s) 2/24 trunk mode set to on.
Port(s) 2/24 trunk type set to isl.
2000 Nov 19 12:32:46 %DTP−5−TRUNKPORTON:Port 2/24
6.
Enable the switch to be a VTP client for the Coriolis VTP domain. Doing so will propagate the
VLAN information from the 1912EN switch:
Catalyst5000> (enable) set vtp domain ?
Usage: set vtp [domain <name>] [mode <mode>] [passwd <passwd>]
[pruning <enable|disable>] [v2 <enable|disable>
(mode = client|server|transparent Use passwd Ô0’ to clear vtp password)
Usage: set vtp pruneeligible <vlans>
(vlans = 2..1000 An example of vlans is 2−10,1000)
Catalyst5000> (enable) set vtp domain Coriolis mode client
VTP domain Coriolis modified.
7.
Related solution: Found on page:
Testing the Supervisor Engine Hardware on a
Set/Clear Command−Based Switch
494
Setting the boot config−register on the Supervisor Engine
Module
Here is an example of setting the boot config−register on the Supervisor Engine module. Let’s look at the
command and the available syntaxes and then an example of using the command:
set boot config−register boot {rommon|bootflash|system} [module number]
Catalyst5000> (enable) set boot config−register boot rommon
Configuration register is 0x0
ignore−config: disabled
auto−config: non−recurring
console baud: 9600
boot: the ROM monitor
Catalyst5000> (enable)
132