Cisco RJ-45-to-AUX - Page 313

Errors: Errors:
FCS errors 0 Late collisions 0
Alignment errors 0 Excessive deferrals 0
Giant frames 0 Jabber errors 0
Address violations 0 Other transmit errors 0
Select [A] Port addressing, [C] Configure port,
[N] Next port, [P] Previous port, [G] Goto port,
[R] Reset port statistics, or [X] Exit to Main Menu:
[A] Port Addressing Report—This option displays the Port Addressing report, which displays the
number of MAC addresses and the MAC addresses assigned to a port:
•
Catalyst 1900 − Port 3 Addressing
Address : Dynamic 00−60−8C−BA−52−14
——————————————————————— Settings ——————————————————
[T] Address table size Unrestricted
[S] Addressing security Disabled
[K] Clear addresses on link down Disabled
[U] Flood unknown unicasts Enabled
[M] Flood unregistered multicasts Enabled
——————————————————————— Actions ——————————————————
[A] Add a static address
[D] Define restricted static address
[L] List addresses
[E] Erase an address
[R] Remove all addresses
[C] Configure port [V] View port statistics
[N] Next port [G] Goto port
[P] Previous port [X] Exit to Main Menu
Enter Selection:
[E] Exception Statistics Report—This option display the Exception Statistics Report, which gives a
summary of errors on a port:
•
Catalyst 1900 − Exception Statistics Report (Frame counts)
Receive Transmit Security
Errors Errors Violations
———————————————————————————————
1 : 0 0 0
2 : 0 0 0
3 : 0 0 0
4 : 0 0 0
5 : 0 0 0
6 : 1 0 0
7 : 0 0 0
8 : 0 0 0
9 : 0 0 0
10 : 0 0 0
11 : 0 0 0
12 : 0 0 0
AUI: 0 0 0
A : 0 0 0
B : 0 0 0
Select [R] Reset all statistics, or [X] Exit to previous menu:
[U] Utilization Statistics Report—This option displays the Utilization Statistics Report, which
displays the utilization of each port:
•
Catalyst 1900 − Utilization Statistics Report (Frame counts)
297