CHAPTER 2
Preparing for Router Installation
This section provides preinstallation information such as recommendations and requirements to review prior
to installing your router.
• Safety Recommendations, on page 15
• General Site Requirements, on page 16
• Rack Requirements, on page 17
• Router Environmental Requirements, on page 17
• Power Guidelines and Requirements, on page 17
• Network Cabling Specifications, on page 18
• Required Tools and Equipment for Installation and Maintenance, on page 20
Safety Recommendations
Follow these guidelines to ensure general safety:
• Keep the chassis area clear and dust-free during and after installation.
• Keep tools and chassis components away from walk areas.
• Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll up your
sleeves.
• Wear safety glasses when working under conditions that might be hazardous to your eyes.
• Do not perform any action that creates a hazard to people or makes the equipment unsafe.
Safety with Electricity
Follow these guidelines when working on equipment powered by electricity:
• Locate the emergency power-off switch in the room in which you are working. If an electrical accident
occurs, you can quickly turn off the power.
• Disconnect all power before doing the following:
• Installing or removing a chassis
• Working near power supplies
• Look carefully for possible hazards in your work area, such as moist floors, ungrounded power extension
cables, frayed power cords, and missing safety grounds.
• Do not work alone if hazardous conditions exist.
Cisco Catalyst IR8340 Rugged Series Router Hardware Installation Guide
15
To Next Page
