Cisco Rugged Series - Installing Pluggable Modules

CHAPTER 4
Power Supply Installation
This chapter describes how to remove and install a new or replacement power supply. Your router ships with
at least one installed power-supply module (AC or DC, depending on your order).
The power-supply modules are field-replaceable units (FRUs) and are hot-swappable when deployed in
non-hazardous locations.
• Power Supply Installation, on page 33
• Power-Supply Modules, on page 33
• Power-Supply Module Installation, on page 35
• Removing the Power Supply Module, on page 44
Power Supply Installation
This chapter describes how to remove and install a new or replacement power supply. Your router ships with
at least one installed power-supply module (AC or DC, depending on your order).
The power-supply modules are field-replaceable units (FRUs) and are hot-swappable when deployed in
non-hazardous locations.
Power-Supply Modules
The following table lists the supported power supply modules. For detailed specifications, see the data sheet.
Table 5: Power Supply Modules
DescriptionModel
High-voltage AC or DC, 100-240VAC 50-60Hz/100-250VDC input, 150 watt
output
PWR-RGD-AC-DC
Low-voltage DC, 24-60VDC input, 150 watt outputPWR-RGD-LOW-DC
High-voltage AC or DC, 100-240VAC 50-60Hz/100-250VDC input, 250 watt
output
PWR-RGD-AC-DC-250
Cisco Catalyst IR8340 Rugged Series Router Hardware Installation Guide
33