Cisco RV016 - Small Business - 10/100 VPN Router - Page 105

Firewall
Configuring Firewall Access Rules
Cisco Small Business RV0xx Series Routers Administration Guide 105
7
priority rule takes precedence. The default access rules have the lowest
priority.
When an access rule is created, the router automatically assigns a priority;
however, you can change the priority after the rule is created.
• Enable: To enable a rule, check the Enable box. To disable a rule, uncheck
the box. You cannot change the default rules.
Additional information appears that cannot be changed on this page:
• Action: The action that the rule performs, to Allow or Deny access
• Service: The service that is affected by this rule
• Source Interface: The source interface that is affected by this rule
• Source: The IP address for the source of the traffic, or Any
• Destination: The IP address for the destination of the traffic, or Any
• Time: A specific time interval when the access rule is active, or Always
• Day: Specific days when the access rule is active, or Always
Add or edit rules as needed.
• To add a rule: Click Add New Rule. Enter the settings, as described in
Configuring Access Rules, page 106.
• To modif y a custom rule: Click the Edit icon. Enter the settings, as
described in Configuring Access Rules, page 106.
• To delete an access rule: Click the Delete icon. When the confirmation
message appears, click OK to continue, or click Cancel to close the
message without deleting the rule.
• To delete all custom rules: Click Restore to Default Rules.