Cisco Small Business RV0xx Series Routers Administration Guide 106
7
Configuring Access Rules
After you click Add New Rule or the Edit icon on the Access Rules table, enter the
following information on the add/edit page.
NOTE Before navigating away from this page, click Save to save your settings. When the
Success message appears, click OK to remain on the current page to add another
access rule, or click Cancel to return to the Access Rules table. To undo your
changes on this page, click Cancel. Any unsaved changes are abandoned.
Services (IPv4 and IPv6)
• Action: Choose the action that the rule performs, to Allow or Deny access.
• Service: Choose the service that is affected by this rule. If you need to add
a service, click Service Management. For more information, see Adding a
service, page 108.
• Log: To include events for this rule in the log, click Log packets match this
rule. Otherwise, click Not log. This setting is applicable when logging is
enabled. For more information, see Chapter 10, “Logging System
Statistics.”.
• Source Interface: Choose the source interface that is affected by this rule.
• Source IP (IPv4) or Source IP / Prefix Length (IPv6): Identify the source
of the traffic that is affected by this rule. From the drop-down list, choose
one of the following options:
- Single: This rule applies to a single IP address. Enter the IP address.
To Next Page
Loading...
Need help?
General
