Cisco Small Business RV0xx Series Routers Administration Guide 77
5
Editing the Dual WAN and Multi-WAN Settings
The Dual WAN Settings page (Multi-WAN Settings on RV016) appears after you
click the Edit icon for a WAN interface on the Dual WAN (or Multi-WAN) page. Enter
the interface settings, as needed.
NOTE Before navigating away from this page, click Save to save your settings, or click
Cancel to undo them. Any unsaved changes are abandoned.
Max Bandwidth Provided by ISP:
In this section, enter the maximum bandwidth settings as specified by your
Internet Service Provider. If the bandwidth exceeds the specified number, then the
router uses another WAN interface for the next connection.
• Upstream: Enter the maximum upstream bandwidth provided by your ISP.
The default is 512 kbit/sec.
• Downstream: Enter the maximum downstream bandwidth provided by
your ISP. The default is 512 kbit/sec.
Network Service Detection:
Optionally, check the box to allow the router to detect network connectivity by
pinging specified devices. Then enter the settings below. Uncheck the box to
disable this feature.
• Retry count: Enter the number of times to ping a device. The default is 5.
• Retry timeout: Enter the number of seconds to wait between pings. The
default is 30 seconds.
• When Fail: Choose the action that will be taken if a ping test fails. If you
choose Generate the Error Condition in the System Log, the router
To Next Page
Loading...
Need help?
General
