Cisco SG500-52P Administration Guide

6
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 82
Administration: General Information
This section describes how to view system information and configure various
options on the device.
It covers the following topics:
• Device Models
• System Information
• Console Settings (Autobaud Rate Support)
• Rebooting the Device
• Routing Resources
• Monitoring Fan Status
• Defining Idle Session Timeout
• Pinging a Host
• Traceroute
Device Models
All models can be fully managed through the web-based switch configuration
utility.
NOTE Each model can be set to Layer 3 system mode by using the System Mode and
Stack Management page, except for the SG500X/ESW2-550X models that always
run in both Layer 2 and Layer 3 system mode.
When the device operates in Layer 3 system mode, the VLAN Rate Limit, and QoS
policers are not operational. Other QoS Advanced mode features are operational.
Only the SG500X/ESW2-550X models support Virtual Router Redundancy
Protocol (VRRP), and Routing Information Protocol (RIP).

Cisco SG500-52P Specifications

General

Model	SG500-52P
Ports	52
PoE Ports	48
PoE+	Yes
Switching Capacity	104 Gbps
Layer	Layer 3
Power over Ethernet (PoE)	Yes
Rack Mountable	Yes
VLAN Support	Yes
Manageable	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	440 x 44 x 350 mm
MAC Address Table Size	16K entries
Operating Temperature	0°C to 50°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90%, non-condensing