Cisco SG500-52P Administration Guide

Security
Defining Users
365 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
20
• Configuring TACACS+
• Configuring RADIUS
• Configuring Port Security
• Configuring 802.1X
• Defining Time Ranges
Protection from other network users is described in the following sections. These
are attacks that pass through, but are not directed at, the device.
• Denial of Service Prevention
• SSL Server
• Defining Storm Control
• Configuring Port Security
• IP Source Guard
• Dynamic ARP Inspection
• Access Control
Defining Users
The default username/password is cisco/cisco. The first time that you log in with
the default username and password, you are required to enter a new password.
Password complexity is enabled by default. If the password that you choose is not
complex enough (Password Complexity Settings are enabled in the Password
Strength page), you are prompted to create another password.
Setting User Accounts
The User Accounts page enables entering additional users that are permitted to
access to the device (read-only or read-write) or changing the passwords of
existing users.
After adding a level 15 user (as described below), the default user is removed
from the system.
NOTE It is not permitted to delete all users. If all users are selected, the Delete button is
disabled.

Cisco SG500-52P Specifications

General

Model	SG500-52P
Ports	52
PoE Ports	48
PoE+	Yes
Switching Capacity	104 Gbps
Layer	Layer 3
Power over Ethernet (PoE)	Yes
Rack Mountable	Yes
VLAN Support	Yes
Manageable	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	440 x 44 x 350 mm
MAC Address Table Size	16K entries
Operating Temperature	0°C to 50°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90%, non-condensing