Cisco SG500-52P Administration Guide

Administration: Stack Management
Default Configuration
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 78
5
Default Configuration
The following are the defaults for the various types of devices in the various
stacking modes:
Interactions With Other Features
RIP and VRRP are not supported in Basic Hybrid Stack Unit mode.
System Modes
Use the System Mode and Stack Management page to perform the following:
• Change the Stack Unit mode of a device to Standalone.
• Change the Stack Unit mode of a device to one of the stacking modes,
change the stack unit ID, stack ports, and the bit rate of the stack port of all
the devices in a stack.
• Change the System mode (Layer 2/3) of a standalone device or of the stack.
• Change the Queues mode from 4 to 8 supported queues or vice versa.
Device
Type
Stack Unit Mode Default Stack Ports Default
System
Mode
Sx500 Native Stack S3-S4 5G Stack Layer 2
Basic Hybrid S3-S4 5G Stack Layer 2
Advanced Hybrid S3-S4 5G Stack Layer 2
SG500X Native Stack S1-S2 10G Stack Layer 2
Basic Hybrid S1-S2 5G Stack Layer 2
Advanced Hybrid S1-S2 5G Stack Layer 2

Cisco SG500-52P Specifications

General

Model	SG500-52P
Ports	52
PoE Ports	48
PoE+	Yes
Switching Capacity	104 Gbps
Layer	Layer 3
Power over Ethernet (PoE)	Yes
Rack Mountable	Yes
VLAN Support	Yes
Manageable	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	440 x 44 x 350 mm
MAC Address Table Size	16K entries
Operating Temperature	0°C to 50°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90%, non-condensing