Cisco SG500-52P Administration Guide

Administration: Discovery
Configuring CDP
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 148
9
- Port ID—Identifier of port advertised in the port TLV.
• Capabilities TLV
- Capabilities—Capabilities advertised in the port TLV)
• Version TLV
- Version—Information about the software release on which the device is
running.
• Platform TLV
- Platform—Identifier of platform advertised in the platform TLV.
• Native VLAN TLV
- Native VLAN—The native VLAN identifier advertised in the native VLAN
TLV.
• Full/Half Duplex TLV
- Duplex—Whether port is half or full duplex advertised in the full/half
duplex TLV.
• Appliance TLV
- Appliance ID—Type of device attached to port advertised in the
appliance TLV.
- Appliance VLAN ID—VLAN on the device used by the appliance, for
instance if the appliance is an IP phone, this is the voice VLAN.
• Extended Trust TLV
- Extended Trust—Enabled indicates that the port is trusted, meaning that
the host/server from which the packet is received is trusted to mark the
packets itself. In this case, packets received on such a port are not re-
marked. Disabled indicates that the port is not trusted in which case, the
following field is relevant.
• CoS for Untrusted Ports TLV
- CoS for Untrusted Ports—If Extended Trust is disabled on the port, this
fields displays the Layer 2 CoS value, meaning, an 802.1D/802.1p priority
value. This is the COS value with which all packets received on an
untrusted port are remarked by the device.
• Power TLV

Cisco SG500-52P Specifications

General

Model	SG500-52P
Ports	52
PoE Ports	48
PoE+	Yes
Switching Capacity	104 Gbps
Layer	Layer 3
Power over Ethernet (PoE)	Yes
Rack Mountable	Yes
VLAN Support	Yes
Manageable	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	440 x 44 x 350 mm
MAC Address Table Size	16K entries
Operating Temperature	0°C to 50°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90%, non-condensing