Cisco SG500-52P Administration Guide

Getting Started
Differences Between Sx500, SG500X and the ESW2-550X Devices
7 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
1
• TCAM size, see Viewing TCAM Utilization[
• System mode. The Sx500 devices can be set to run in either Layer 2 or
Layer 3 system modes. The SG500X/ESW2-550X devices always run in
both Layer 2 and Advanced Layer 3 system mode.
• Stack ports are different on these devices. See Stack Ports.
• Port speed availability per cable types are different on these devices. See
Cables Types.
• Enabling IPv4 routing is done differently in the two types of devices, as
follows:
- SG500X/ESW2-550X—IPv4 routing must be enabled in the IPv4
Interface page.
- Sx500—When the device is switched from Layer 2 to Layer 3 system
mode, IPv4 routing is automatically enabled.

Cisco SG500-52P Specifications

General

Model	SG500-52P
Ports	52
PoE Ports	48
PoE+	Yes
Switching Capacity	104 Gbps
Layer	Layer 3
Power over Ethernet (PoE)	Yes
Rack Mountable	Yes
VLAN Support	Yes
Manageable	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	440 x 44 x 350 mm
MAC Address Table Size	16K entries
Operating Temperature	0°C to 50°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90%, non-condensing