Cisco SG500-52P Administration Guide

Access Control
IPv4-based ACLs
467 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
24
- UDP —User Datagram Protocol
-
HMP —Host Mapping Protocol
-
RDP —Reliable Datagram Protocol.
-
IDPR —Inter-Domain Policy Routing Protocol
-
IPV6 —IPv6 over IPv4 tunneling
-
IPV6:ROUT —Matches packets belonging to the IPv6 over IPv4 route
through a gateway
-
IPV6:FRAG —Matches packets belonging to the IPv6 over IPv4 Fragment
Header
-
IDRP —Inter-Domain Routing Protocol
-
RSVP —ReSerVation Protocol
-
AH —Authentication Header
-
IPV6:ICMP —Internet Control Message Protocol
-
EIGRP —Enhanced Interior Gateway Routing Protocol
-
OSPF —Open Shortest Path First
-
IPIP —IP in IP
-
PIM —Protocol Independent Multicast
-
L2TP —Layer 2 Tunneling Protocol
-
ISIS —IGP-specific protocol
• Protocol ID to Match—Instead of selecting the name, enter the protocol ID.
• Source IP Address—Select Any if all source address are acceptable or
User defined to enter a source address or range of source addresses.
• Source IP Address Value—Enter the IP address to which the source IP
address is to be matched.
• Source IP Wildcard Mask—Enter the mask to define a range of IP
addresses. Note that this mask is different than in other uses, such as subnet
mask. Here, setting a bit as 1 indicates don't care and 0 indicates to mask that
value.

Cisco SG500-52P Specifications

General

Model	SG500-52P
Ports	52
PoE Ports	48
PoE+	Yes
Switching Capacity	104 Gbps
Layer	Layer 3
Power over Ethernet (PoE)	Yes
Rack Mountable	Yes
VLAN Support	Yes
Manageable	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	440 x 44 x 350 mm
MAC Address Table Size	16K entries
Operating Temperature	0°C to 50°C
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90%, non-condensing