Cisco SIP IP Phone User Manual

C-2
Cisco SIP IP Phone Administrator Guide
Appendix C Technical Specifications
Cable Specifications
Cable Specifications
The following cables are required to connect the Cisco SIP IP phone:
• RJ-11 for the handset connection
• RJ-45 jack for the LAN connection (labeled “10/100 SW”).
• RJ-45 jack for a second 10Base-T compliant connection (labeled “10/100 PC”).
• 48-volt power connector. The diameter of the center pin in the phone power jack (Switchcraft 712A)
is .1 inches (2.5 mm). The center pin is positive (+) voltage. The miniature power plug required to
mate with the power jack on the phone is a Switchcraft 760 or equivalent.
Regulatory Safety Compliance
The Cisco IP Phone models 7960, 7940, and 7910 meet the following regulatory safety and compliance
approvals:
• CE Marking
• Safety
– UL1950
– CSA C22.2 No. 950
– EN 60950
– IEC 60950
– AS/NZS 3260
– TS001
• EMC
– AS/NZS 3548 Class B
– VCCI Class B
– FCC (47CFR) Part 15 Class B
– EN 55022, Class B
• Telecom
– IC CS-03
– FCC (47CFR) Part 68
Figure C-1 contains the FCC Class B Declaration for the Cisco IP Phone 7960, 7940, 7910, and
7910+SW.

Cisco SIP IP Phone Specifications

General

Brand	Cisco
Model	SIP IP Phone
Category	IP Phone
Language	English