Cisco UCS 5108 - Page 23

Cisco UCS 5108 Blade Server Chassis
SUPPLEMENTAL MATERIAL
23
For the B200/B230 M1/M2 blade servers, supported card adapter combinations are shown in Table 17.
The general connectivity diagrams between the mezzanine adapter cards and the different fabric extenders
are shown in
Figure 9 on page 24 through Figure 11 on page 25.
Table 15 Adapter Card Options
Fabric
Extender
Compatibility
Adapter in Mezzanine Connector
Ports
1
Notes . . .
1. Cisco-designed adapters are capable of port channeling. A port channel bundles up to four individual interfaces
into a group to provide increased bandwidth and redundancy. Port channeling also load balances traffic across
these physical interfaces. The port channel stays operational as long as at least one physical interface within
the port channel is operational. Cisco-certified adapters suppled by third-party vendors do not support port
channeling. Port channeling is indicated with an oval drawn around several individual ports.
2208XP
2208XP M81KR 2 x 10 Gb
2208XP
VIC 1280
2
2. Available only on M2 and M3 servers (not available on M1 servers)
8 x 10 Gb
2208XP
Cisco-certified mezzanine adapter
3
3. Cisco-certified mezzanine adapters are manufactured by third-party vendors and are certified by Cisco for use
in the servers. For more information about supported Cisco-certified mezzanine adapters, see
http://www.cisco.com/en/US/docs/unified_computing/ucs/hw/chassis/install/blade.html#wp1010426
2 x 10 Gb
2204XP
2204XP M81KR 2 x 10 Gb
2204XP
VIC 1280
2
4 x 10 Gb
2204XP
Cisco-certified mezzanine adapter
3
2 x 10 Gb
2104XP
2104 XP M81KR 2 x 10 Gb
2104 XP
VIC 1280
2
2 x 10 Gb
2104XP
Cisco-certified mezzanine adapter
3
2 x 10 Gb