Cisco UCS 5108 Spec Sheet

Cisco UCS 5108 Blade Server Chassis
SUPPLEMENTAL MATERIAL
41
SFP+ Transceivers
Each Cisco Fabric Extender within the chassis supports Small Form-Factor Pluggable (SFP+) copper or
optical transceivers. Each transceiver runs at 10 Gbs.
Copper SFP+ Twinax Transceivers
The Cisco Fabric Extenders support Twinax copper transceivers with twinax cables of various lengths. The
assembly consists of two transceivers connected by a twinax copper cable. The enhanced SFP+ 10-Gb
Ethernet transceiver is a bidirectional device with a transmitter and receiver in the same physical package.
It has a 20-pin connector on the electrical interface.
Figure 25 shows the SFP-H10GB-CU5M transceiver. The rubber loop is used for removing the SFP+ from its
port on the I/O module.
Figure 25 SFP+ 10 Gb Twinax Copper Transceiver
187492

Cisco UCS 5108 Specifications

General

Number of Blade Slots	8
I/O Module Bays	2
Supported Blade Servers	Cisco UCS B-Series Blade Servers
Power Supply Options	Up to four hot-swappable power supplies (AC or DC)
Cooling	Redundant hot-swappable fans
Management	Cisco UCS Manager
Blade Slots	8
Fabric Interconnects	Cisco UCS 6100 or 6200 Series
Power Supplies	Up to 4 hot-pluggable power supplies
Form Factor	6RU rack-mountable