CHAPTER
5-1
Cisco VG350 Voice Gateway Hardware Installation Guide
OL-25970-01
5
Powering On the Cisco VG350 Voice Gateway
To power on your Cisco VG350 Voice Gateway, perform the following tasks in the order listed, as
required:
• Checklist for Power-On, page 5-1
• Power-On Procedure, page 5-1
• Troubleshooting, page 5-3
Checklist for Power-On
You can power on a Cisco VG350 Voice Gateway if it meets the requirements described in
Chapter 4, “Installing the Cisco VG350 Voice Gateway”:
• The chassis is securely mounted.
• Power cable is connected.
• Interface cables are connected.
Power-On Procedure
Perform this procedure to power on your Cisco VG350 Voice Gateway, and verify that it goes through
its initialization and self-test. When this is finished, the Cisco VG350 Voice Gateway is ready to
configure.
Warning
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit.
Statement 1028
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
To Next Page
Loading...
Need help?
General
