Planning Your Wireless Network
Network Layout
WAP4410N Wireless-N Access Point with Power Over Internet 4
2
Network Layout
The Wireless-N Access Point has been designed for use with 802.11n, 802.11g
and 802.11b products. The access point is compatible with 802.11n, 802.11g and
802.11b adapters, such as the notebook adapters for your laptop computers, PCI
adapters for your desktop PCs, and USB adapters for all PCs when you want to
enjoy wireless connectivity. These wireless products can also communicate with a
802.11n, 802.11g or 802.11b wireless print server (if available).
To link your wired network with your wireless network, connect the access point’s
Ethernet network port to any switch or router with Power over Ethernet (PoE)—or a
PoE injector, such as the Cisco WAPPOE or WAPPOE12. Note that the 12 VDC on
the WAPPOE12 is for the splitter output.
With these, and many other, Cisco products, your networking options are limitless.
Go to the Cisco website at www.cisco.com for more information about wireless
products.
Example of a Simple Wireless Network
The diagram below shows a typical infrastructure wireless network setup.
To Next Page
Loading...
