Cisco WAP4410N - Small Business Wireless-N Access Point - Configuring Connection Control

Configuring the WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet 39
6
To enable wireless Wired Equivalent Privacy (WEP) security, follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WEP.
STEP 3 To enable wireless isolation within the SSID, click Enabled.
STEP 4 Provide the following information:
• Authentication Type—Choose Open System or Shared Key as the 802.11
authentication type. The default is Open System.
• Default Transmit Key—Select the key to be used for data encryption.
• WEP Encryption—Select a level of WEP encryption, 64 bits (10 hex digits)
or 128 bits (26 hex digits).
• Passphrase—To generate WEP keys using a passphrase, then enter the
passphrase in the Passphrase field and click Generate. The auto-generated
keys are not as strong as manual WEP keys.
• Key 1-4—To manually create WEP keys, enter these keys in the Key 1, Key
2, Key 3, and Key 4 fields. Each WEP key can consist of the letters “A”
through “F” and the numbers “0” through “9.”. A key should be 10 characters
in length for 64-bit encryption or 26 characters in length for 128-bit
encryption.
STEP 5 Click Save.
Configuring Connection Control
The Wireless > Connection Control Settings page displays the wireless
connection settings.
• “Disabling Connection Control” on page 40
• “Enabling Local Connection Control” on page 41
• “Enabling RADIUS Connection Control” on page 42