Cisco WAP4410N - Small Business Wireless-N Access Point - Appendix A: Troubleshooting and Help; Frequently Asked Questions

Configuring the WAP4410N Wireless-N Access Point
Administration
WAP4410N Wireless-N Access Point with Power Over Internet 57
6
Restoring Factory Default Settings
The Administration > Factory Default page allows you to restore the access point’s
factory default settings.
To restore factory default settings of the access point, follow these steps:
STEP 1 Open the Restore Factory Default page (Administration > Factory Default).
STEP 2 Restore the Factory Default settings.
Restoring Factory Defaults
Note any custom settings before you restore the factory defaults. Once the access
point is reset, you will have to re-enter all of your configuration settings.
• Restore Factory Defaults—To restore the access point's factory default
settings, click the Yes radio button. Then, click Save Settings. Your access
point will reboot and come back up with the factory default settings in a few
seconds.
Click Save Settings to apply your change, or click Cancel Changes to cancel your
change. Help information is displayed on the right-hand side of the screen.