Cisco WAP4410N - Small Business Wireless-N Access Point - Configuring Advanced Settings

Configuring the WAP4410N Wireless-N Access Point
Setting Up Your Access Point
WAP4410N Wireless-N Access Point with Power Over Internet 23
6
d. To get the time from a local NTP server, in the User Defined NTP Server field,
click Enabled.
e. In the NTP Server IP field, enter the IP address of the NTP server.
• User Defined NTP Server—Enable this option if you have set up local NTP
server. Default is Disabled.
• NTP Server IP—Enter the IP address of user defined NTP Server.
STEP 4 Click Save.
Configuring Advanced Settings
The Setup > Advanced Settings page displays advanced settings.