Cisco WAP4410N - Small Business Wireless-N Access Point - Configuring Advanced Settings

Configuring the WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet 46
6
Configuring Advanced Settings
The Wireless > Advanced page allows you to configure the advanced and load
balancing settings for the access point.
The Wireless-N adopts several new parameters to adjust the channel bandwidth,
and guard intervals to improve the data rate dynamically.
We recommend you let your access point automatically adjust the parameters for
maximum data throughput.
To configure the wireless advanced settings for the access point, follow these
steps:
STEP 1 Click Wireless > Advanced.
STEP 2 In the Options section, configure the following advanced parameters (some only
for Wireless-N) for this access point:
• Country/Region—Choose the country for your location from the drop-
down list.
• Worldwide Mode (802.11d)—Click Enabled to enable this mode. Your
wireless stations must support this mode for this setting to work.