Cisco WAP4410N - Small Business Wireless-N Access Point - Configuring Security

Configuring the WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet 27
6
Configuring Security
The Wireless > Security page displays the wireless security settings of the
access point.
To configure the wireless security settings of the access point, follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 To configure wireless isolation between SSIDs:
a. From the Select SSID drop-down menu select an SSID.
b. To isolate wireless clients from each other, click Enabled. Otherwise, click
Disabled.
STEP 3 To disable wireless security completely, from the Security Modes drop-down,
select Disabled.
This is the default setting.