Cisco WAP4410N - Small Business Wireless-N Access Point - Page 44

Configuring the WAP4410N Wireless-N Access Point
Wireless
WAP4410N Wireless-N Access Point with Power Over Internet 35
6
Configuring WPA2-Enterprise Mixed Security
This security mode supports the transition from WPA-Enterprise to WPA2-
Enterprise. You can have client devices that use either WPA-Enterprise or WPA2-
Enterprise. The access point will automatically choose the encryption algorithm
used by each client device.
!
CAUTION Use this mode only when a RADIUS server is connected to the access point.
To enable wireless WPA2-Enterprise Mixed security, follow these steps:
STEP 1 Click Wireless > Security.
STEP 2 From the Security Mode drop-down menu, select WPA2-Enterprise Mixed.
STEP 3 To enable wireless isolation within the SSID, click Enabled.