Configuring the WAP4410N Wireless-N Access Point
Configuring the AP Mode
WAP4410N Wireless-N Access Point with Power Over Internet 50
6
To configure the AP mode of the access point, follow these steps:
STEP 1 Click AP Mode > AP Mode.
STEP 2 Configure the AP Mode settings.
• Access point—Select this option to let the device operate as a normal
access point.
- Allow Wireless Signal to be repeated by a repeater—If selected, the
device will act as a repeater for another access point. Provide the MAC
addresses of the other access points in the fields.
• Wireless WDS Repeater—Select this option to let the access point
operates as a wireless repeater to extend the radio range of the associated
remote access point to overcome any obstacle that blocks radio
communication.
- Remote Access Point’s MAC Address—Enter the MAC address of the
remote access point directly, or click the Site Survey button to select
from a list of available access points.
• Wireless WDS Bridge—Select this option to let the access point operates
as a wireless bridge to perform transparent bridging with other associated
wireless bridges, and not allow any wireless client or station to access
them.
- Remote Wireless Bridge’s MAC Address—Enter the MAC addresses
of the other access points in the fields.
• Wireless Client/Repeater—Select this option to let the wireless access
point operate as a client or repeater access point, sending all traffic
received to another access point.
- Allow wireless stations to associate—Enable or disable this setting.
- Remote access point—Enter the MAC address and SSID of the desired
access point or click the Site Survey button to choose the access point
from the available networks.
To Next Page
Loading...
