Cisco WAP4410N - Small Business Wireless-N Access Point - Page 71

Configuring the WAP4410N Wireless-N Access Point
Configuring Status Settings
WAP4410N Wireless-N Access Point with Power Over Internet 62
6
To check local network status, follow these steps:
STEP 1 Click Status > Local Network.
This page displays the status information of your access point:
• Information
- Hardware Version—The version of the access point’s current hardware.
- Software Version—The version of the access point’s current software.
- Local MAC Address—The MAC address of the access point’s local
network interface.
- System Up Time—The length of time the access point has been running
for.
• Local Network
- IP Address—The access point’s IP address as it appears on your local
network.
- Subnet Mask—The access point’s subnet mask.
STEP 2 To update the status information, click Refresh.