Cisco WS-C3020 - Page 10

Contents
x
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
Configuring Web Authentication 8-41
Disabling IEEE 802.1x Authentication on the Port 8-44
Resetting the IEEE 802.1x Authentication Configuration to the Default Values 8-44
Displaying IEEE 802.1x Statistics and Status 8-45
CHAPTER 9 Configuring Interface Characteristics 9-1
Understanding Interface Types 9-1
Port-Based VLANs 9-2
Switch Ports 9-2
Internal Gigabit Ethernet Ports 9-3
Access Ports 9-3
Trunk Ports 9-3
Tunnel Ports 9-4
Routed Ports 9-4
Switch Virtual Interfaces 9-5
EtherChannel Port Groups 9-5
Dual-Purpose Uplink Ports 9-6
Connecting Interfaces 9-6
Management-Only Interface 9-7
Using Interface Configuration Mode 9-7
Procedures for Configuring Interfaces 9-8
Configuring a Range of Interfaces 9-9
Configuring and Using Interface Range Macros 9-10
Configuring Ethernet Interfaces 9-12
Default Ethernet Interface Configuration 9-12
Setting the Type of a Dual-Purpose Uplink Port 9-13
Configuring Interface Speed and Duplex Mode 9-15
Speed and Duplex Configuration Guidelines 9-15
Setting the Interface Speed and Duplex Parameters 9-16
Configuring IEEE 802.3x Flow Control 9-17
Configuring Auto-MDIX on an Interface 9-18
Adding a Description for an Interface 9-19
Configuring Layer 3 Interfaces 9-19
Configuring the System MTU 9-21
Monitoring and Maintaining the Interfaces 9-22
Monitoring Interface Status 9-23
Clearing and Resetting Interfaces and Counters 9-23
Shutting Down and Restarting the Interface 9-24