Cisco WS-C3020 - Page 27

Contents
xxvii
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
Understanding Layer 2 Trunk Failover 33-20
Configuring Layer 2 Trunk Failover 33-21
Default Layer 2 Trunk Failover Configuration 33-21
Layer 2 Trunk Failover Configuration Guidelines 33-22
Configuring Layer 2 Trunk Failover 33-22
Displaying Layer 2 Trunk Failover Status 33-23
CHAPTER 34 Configuring IP Unicast Routing 34-1
Understanding IP Routing 34-1
Types of Routing 34-2
Steps for Configuring Routing 34-3
Configuring IP Addressing 34-3
Default Addressing Configuration 34-4
Assigning IP Addresses to Network Interfaces 34-5
Use of Subnet Zero 34-5
Classless Routing 34-6
Configuring Address Resolution Methods 34-7
Define a Static ARP Cache 34-8
Set ARP Encapsulation 34-9
Enable Proxy ARP 34-9
Routing Assistance When IP Routing is Disabled 34-10
Proxy ARP 34-10
Default Gateway 34-10
ICMP Router Discovery Protocol (IRDP) 34-11
Configuring Broadcast Packet Handling 34-12
Enabling Directed Broadcast-to-Physical Broadcast Translation 34-12
Forwarding UDP Broadcast Packets and Protocols 34-13
Establishing an IP Broadcast Address 34-14
Flooding IP Broadcasts 34-15
Monitoring and Maintaining IP Addressing 34-16
Enabling IP Unicast Routing 34-17
Configuring RIP 34-17
Default RIP Configuration 34-18
Configuring Basic RIP Parameters 34-19
Configuring RIP Authentication 34-20
Configuring Summary Addresses and Split Horizon 34-21
Configuring Split Horizon 34-22