Cisco WS-C3020 - Page 28

Contents
xxviii
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
OL-8915-03
Configuring Stub Routing 34-23
Understanding PIM Stub Routing 34-23
Configuring PIM Stub Routing 34-24
PIM Stub Routing Configuration Guidelines 34-24
Enabling PIM Stub Routing 34-24
Understanding EIGRP Stub Routing 34-26
Configuring EIGRP Stub Routing 34-27
Configuring Protocol-Independent Features 34-27
Configuring Cisco Express Forwarding 34-28
Configuring the Number of Equal-Cost Routing Paths 34-29
Configuring Static Unicast Routes 34-30
Specifying Default Routes and Networks 34-31
Using Route Maps to Redistribute Routing Information 34-31
Filtering Routing Information 34-34
Setting Passive Interfaces 34-34
Controlling Advertising and Processing in Routing Updates 34-34
Filtering Sources of Routing Information 34-35
Managing Authentication Keys 34-36
Monitoring and Maintaining the IP Network 34-37
CHAPTER 35 Configuring IPv6 Host Functions 35-1
Understanding IPv6 35-1
IPv6 Addresses 35-2
Supported IPv6 Unicast Host Features 35-3
128-Bit Wide Unicast Addresses 35-3
DNS for IPv6 35-4
ICMPv6 35-4
Neighbor Discovery 35-4
IPv6 Stateless Autoconfiguration and Duplicate Address Detection 35-4
IPv6 Applications 35-9
Dual IPv4 and IPv6 Protocol Stacks 35-10
SNMP and Syslog Over IPv6 35-10
HTTP(S) Over IPv6 35-12
Dual IPv4 and IPv6 SDM Templates 35-12
Configuring IPv6 35-13
Default IPv6 Configuration 35-13
Configuring IPv6 Addressing and Enabling IPv6 Host 35-14
Configuring IPv6 ICMP Rate Limiting 35-15
Configuring Static Routes for IPv6 35-16
Displaying IPv6 35-18