Chapter 2 Printer Operation
28
List of Mode Items
Indication Description
Transfer Thermal transfer printing is performed
Printing method
DirectTM Direct thermal printing is performed
PeelWait Selected when peeler (option) is used
AutoCut Selected when auto-cutter (option) is used
TearBar Media is automatically advanced to the cut position after printing
Operation after
printing
NoAction No operation is performed after printing
Edge
Transparent type sensor is used to detect the media position with
media gaps or notches
Reflect
Reflective type sensor is used to detect the media position with
black marks
Media sensor
ContinuP Printing on continuous media is performed without detecting
media gaps
Heat 01
:
Print density
Heat 30
Print density is set
Pspeed 2
:
Printing speed
Pspeed 7
Printing speed is set
Fspeed 2
:
Feed speed
Fspeed 7
Feed speed is set
Bspeed 2
:
Back-feed speed
Bspeed 7
Back-feed speed is set
V-2.00in
:
Print start
position
V+2.00in
Print start position is set (relative value to default value is used)
H 0.00in
:
Column offset
H+2.00in
Column offset (horizontal direction) is set
S-2.00in
:
Media stop
position
S+2.00in
Media stop position is set (relative values to default values for
peeling, auto-cutter, tearing are used)
SetLckOF Printing mode settings are allowed with command
Command
overriding
SetLckON Printing mode settings are not allowed with command
Note: When the printer is switched off and on, the initial values for these menu items selected by
the printer configuration setting mode will be retrieved from the flash memory.
3 Printer Configuration Setting Mode
To Next Page
Loading...
