Citizen CLP-7202e - Page 31

Chapter 2 Printer Operation

29
Notes when setting print start position and media stop position
• When the “AfterPnt” menu item is set to “AutoCut”, the relation between print start position and
media stop position should be set to [
∆ O ≥ ∆ f]. If the value is set so that [ ∆ O < ∆ f], the media may be
out of platen.
• If the absolute value to O value is larger than the absolute value to f value as the set value of [ ∆ O]
increases, the media stop position may change. However, if the absolute value to f value is smaller
than the absolute value to O value as the set value of [
∆ f] decreases, the media stop position may
not change.
• When the “AfterPnt” menu item is set to “PeelWait”, the set value of [ ∆ f] should be limited; the larger
value causes labels to unexpectedly peel off.
3 Printer Configuration Setting Mode
Liner
Labels
Media sensor
Printhead
Platen
A
uto-cutte
r

O value
f value (NoAction)
←→
∆ f (Stop Pos)
Print start position: Relative value to O value
(Vert Adj) is set (
∆ O)
Print start position: Relative value to O value
(Stop Pos) is set (
∆ f)
Direction of media feed
←→
∆
f
(
Sto
p
Pos
)

←→
∆ f (Stop Pos)
←→
∆ f (Stop Pos)
←→
∆ O (Vert Adj)
12.8mm (Peel)
17.4mm (Tear)

29.0mm
(
Cut
)

A
ctual distance
f value (AutoCut)
f value (TearBar)
f value (PeelWait)