CITROEN 2001 BERLINGO - Adjusting the Belt Fitting Tension; Checking the Belt Tension

107
CHECKING AND SETTING THE VALVE TIMING
Engines : CDZ - HDZ - HFX - KFX - KFW - NFZ - NFT (Continued).
PRE-TENSIONING THE TIMING BELT (Cont.).
- Ensure the timing is correctly set by refitting the pegs [1] and [2].
- Remove the cylinder head cover.
- Fit the tool [5] (Ensure it is fitted in the right direction in relation to the timing).
ADJUSTING THE BELT FITTING TENSION.
- Fit the tool [4] to the tightened belt strip.
- Loosen the nut (2).
- Slacken the belt (not excessively).
- Tighten the timing belt to obtain : 31 ± 2 SEEM units.
- Tighten the nut (2) to 2.2 m.daN.
- Remove the tools [1] [2] [4] and [5].
CHECKING THE BELT TENSION.
- Rotate the crankshaft by 2 turns in the normal direction of rotation.
- Check that the following components can still be pegged :
- Flywheel.
- Camshaft.
ESSENTIAL : If the components cannot be pegged, repeat the belt tensioning procedure.
ENGINE