248
CLUTCH
GEARBOX
DRIVESHAFTS
4 HP 14 AUTOMATIC GEARBOX - CHECKS AND ADJUSTMENTS
Engine : RFV
Adjusting the gear selector
Tools
[1] Ball-joint extractor 9040-T.G2 Tool kit 9040-T
- Uncouple the ball-joint housing (1) from the selector lever using tool [1].
CAUTION : Do not twist the rod (2) of the selector cable when uncoupling.
- Gear lever in position N (Normal).
- Selector lever (5) in position N.
- Loosen the nuts (3).
- Position the ball-joint housing (1) opposite the ball-joint (4).
- Fit the ball-joint housing (1) to the selector lever (5) ball-joint (4).
- Tighten the nut (3).
Check that :
- The gear selector works correctly in all the positions.
- The "starter" function only works in positions P and N.
B2CP010C
B2CP27XC
B2CP27YC
XSARA
To Next Page
Loading...
