199
INJECTION
CHECKING AND SETTING THE BOSCH MECHANICAL INJECTION PUMP
TOOLS
- Flywheel locating peg : 7017-T.R. Tool kit 7004-T
- Ring spanner : 4132-T.
- Crescent spanner FACOM 57 : 11 X 13
- Dial gauge : 3089-T.H.
- Dial gauge bracket : 7010.T. Tool kit 4123-T.
- 31 mm lever : 5003-T.D.
SETTING THE INJECTION PUMP.
- Tilt the pump in the retarded direction (away from the engine).
- Fit the timing tool.
- Turn the engine (direction of engine rotation) until the peg engages in the flywheel.
- Ensure that the pump pinion can be pegged (if not, rotate the crankshaft by 1 turn).
- Remove the tool 7017-T.R
- Find the BDC position of the pump (by turning the crankshaft backwards) and set
the dial gauge to ‘‘0’’.
- Turn the crankshaft (direction of engine rotation) until the locating peg 7017-T.R engages.
- Turn the pump, in the advance direction (towards the engine) until the dial gauge shows
(See the table on pages : 197).
NOTE : The dial gauge needle must not move when tightening.
B1HP0YKD
Engine : DHY
XSARA
To Next Page
Loading...
