189
INJECTION
ADJUSTING THE DELPHI MECHANICAL INJECTION PUMP CONTROLS
Engines : VJZ - VJY - VJX (continued)
ADJUSTING THE ACCELERATOR CONTROL.
Engine stopped.
- Fully depress the accelerator pedal.
- Check that the lever (5) is against its stop (6), otherwise, alter the position of the clip (7)
(Accelerator cable tension).
- Ensure that in the idle position the lever (5) is against the stop (8).
Adjusting the anti-stall (Residual output).
- Insert a 1.5 mm thick shim between the lever (5) and the residual output adjustment
screw (8).
- Adjust the residual output adjustment screw (8) to obtain an engine speed of 1600 ± 100 rpm
- Remove the 1.5 mm thick shim.
Idling speed.
Adjust the idle speed adjustment screw (9) to obtain a speed of 800 ± 25 rpm.
B1HP090D
SAXO - XSARA
To Next Page
Loading...
