249
CLUTCH
GEARBOX
DRIVESHAFTS
4 HP 14 AUTOMATIC GEARBOX - CHECKS AND ADJUSTMENTS
Engine : RFV
Preliminary conditions :
- Engine hot.
- Idling speed correct.
- Automatic cold start device out of action (according to equipment).
Accelerator cable adjustment :
- Remove the kick down cable (1) from the throttle quadrant.
- Pull out the sheath stop (2) and fit the spring clip (3) so as to obtain a small
clearance.
- Press the accelerator pedal fully down.
- Ensure that the throttle is fully open.
Kick down cable adjustment:
- Pull the cable until the point of resistance.
(Start of kick down command A = 39 mm).
- The lug (4) must be positioned and crimped on the cable.
- Refit the kick down cable (1) on the throttle quadrant.
- Adjust the clearance (B) from 0.5 mm to 1 mm max. by tightening the nuts (5).
Checks - Adjustments : Kick down cable
B2CP35GC
B2CP35HC
B2CP35KCB2CP35JC
XSARA
To Next Page
Loading...
