132
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine : DHY
TOOLS
- Crankshaft locating peg : 7014 - T.J or 7014 - T.R
- Camshaft and injection pump locating peg : 7004 - T.G Tool kit 7004-T.
CHECKS
- Peg the crankshaft.
- Peg the pulleys (1) and (2) at "a" and «b».
SETTING THE VALVE TIMING.
- Peg the crankshaft.
- Peg the pulleys (1) at "a" and (2) at «b».
- Fit the belt in the following order :
Crankshaft pinion, guide roller (3), injection pump pulley (2), camshaft pulley (1), tensioner roller (5),
water pump (4).
- Remove the pegs.
- Free the tensioner roller (5) (nut (6) and screw (7)), retighten the screw (7).
- Rotate the crankshaft by 2 turns. Do not turn backwards.
- Loosen the tensioner roller (5), allow the tensioner to operate.
- Retighten the screw (7) and the nut (6). Tighten to 1.8 m.daN.
- Check the setting.
NOTE : The injection pump is removed without changing the valve timing. (immobilise the injection pump
pulley using the screws (8x125) at «b»).
B1EP09KC B1EP080C
To Next Page
Loading...
