ENGINE
97
CHECKING AND SETTING THE VALVE TIMING
Engine : LFX (continued)
SETTING THE VALVE TIMING
- Fit the tension measuring tool to the middle of the belt strip "c".
- Turn the tensioner roller (2) (anti-clockwise direction) using the tool 7017-T.W to obtain the following
measurement : 30 ± 2 SEEM units.
- Tighten the screw (1) to 2 m.daN.
- Remove the tools.
- Rotate the crankshaft by two turns (do not turn backwards).
- Check the setting by positioning the pegs at "a" and "b".
- Remove the pegs.
CHECKING THE TENSION
- Rotate the crankshaft by two turns (do not turn backwards).
- Peg the camshaft pulley at "a".
- Fit the tension measuring tool on the belt strip at "c".
- The tension measurement should be 44 ± 2 SEEM units.
(If the measurement is not correct, repeat the tensioning procedure).
- Remove the tools.
B1EP07RC
To Next Page
Loading...
