CITROEN C2 - Page 122

116
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engine: 8HY
B1BP2N0C
Tools.
[1] Engine flywheel peg Ø 12 mm : (-).0194-C
[2] Camshaft pulley peg Ø 8 mm : (-).0194-B
[3] Crankshaft pulley peg Ø 5 mm : (-).0194-A
Preliminary operations.
Remove:
- The front RH wheel.
- The front RH splash-shield.
- The accessories belt
(see corresponding operation) .
Uncouple:
- The supply unions (1).
- The air/air heat exchanger inlet/outlet pipes (3).
- The exhaust line (at the flexible pipe) .
Disconnect the connector (2).
Support the engine by means of a roller jack equipped with a chock.
Remove the engine supports (4) and (5).
C3
Angl.-T1-page 92-134-2005 9/01/06 9:16 Page 116