182
CLUTCH
GEARBOX
TRANSMISSION
AL4 GEARBOX CONTROLS
In passenger compartment.
The gear selector is guided by the shape of the stepped gate and by a retaining spring which
pulls it to the left hand side.
The gear selector control has 5 positions.
Position «P»: Park
(locking and immobilisation of the vehicle)
.
Position «R»: Reverse gear.
Position «N»: Neutral.
Position «D»: Drive
(use of the 4 gears in their autoadaptive automatic function).
Position «M»: Manual
(this position lets the driver select his own gears in sequential mode
by pulling the gear selector to «M-» or pushing it to «M+»)
.
NOTE: Only the positions «P» or «N» authorise the starting of the engine.
In position «M», selection is by an electronic sensor located close to the gear lever.
The variation of flux necessary to the movement of the sensor cells is obtained by a magnet
located on the lever itself. This enables the change of status.
C3
B2CP3H7D
To Next Page
Loading...
