202
AXLES
SUSPENSION
STEERING
C3 AXLE GEOMETRY
B3CP07SD
Measuring front height Measuring rear height
[1] Gauge for measuring the wheel radius, 4 bolts, tool 4003-T or 8006-T
(according to version)
.
Z1 = Measuring zone underneath the front subframe. Z2 = Measuring zone underneath the rear sill..
Measure the radius of the front wheel R1 - Calculate dimension H1 = R1–L1 Measure the radius of the rear wheel R2 - Calculate dimension H2 = R2+L2
All types except CRD (*) CRD (*) All types except CRD (*) CRD (*)
Value at reference
Raised suspension Raised suspension
Value at reference
Raised suspension Raised suspension
height Administration vehicle Administration vehicle height Administration vehicle Administration vehicle
(+ 6 - 8 mm) C3 version XTR C3 version XTR (+ 10 - 6 mm) C3 version XTR C3 version XTR
L1 = 142,5 mm L1 = 132,5 mm L2 = 52 mm L2 = 62 mm
(*) = CRD: Difficult road conditions.
Definition for a type of vehicle whose axles and suspensions are adapted for driving on rough roads. Compress the suspension to obtain the calculated
values. The height difference between the two axle wheel should be less than 10 mm.
Checks at reference height
To Next Page
Loading...
Need help?
General
