CITROEN C2 - Checking the Valve Timing

126
ENGINE
CHECKING THE VALVE TIMING
Engine: 9HX
Move aside the harness (6).
Remove:
- The engine support (7).
- The screw (8).
- The accessories drive pulley (9).
- The lower timing cover (10).
- The upper timing cover (11).
- The tool [1].
Refit the screw (8).
Rotate the crankshaft six times clockwise.
IMPERATIVE: Never turn it backwards.
Peg the camshaft using tool [2]
(oil the peg) .
WARNING: The magnetic track should not show any sign of damage and should not be approached
by any other magnetic source.
Peg the crankshaft using tool [3] at «b».
ESSENTIAL: Should it not be possible to peg the camshaft, check that the offset between the cam-
shaft pinion hole and the pegging hole is not more than 1 mm. If it is more, repeat the operation to
position the timing belt (see corresponding operation) .
C3
B1BP2N2C
B1EP1HSD
Angl.-T1-page 92-134-2005 9/01/06 9:16 Page 126