C2
AXLE GEOMETRY
Tyres inflated to correct pressures. Vehicle at reference height. Steering rack locked at mid point
(see corresponding operation)
.
Conditions for checking and adjusting
Vehicle heights at reference height
E1APOBZD
Front height Rear height
L1 L2
H1 = R1 – L1 H2 = R2 + L2
H1 = Measurement between the measuring zone underneath the front H2 = Measurement between the measuring zone underneath the rear
subframe and the ground. sill and the ground.
R1 = Front wheel radius under load. R2 = Rear wheel radius under load.
L1 = Distance between the wheel axis and the measuring zone L2 = Distance between the wheel axis and the measuring zone
underneath the front subframe. underneath the rear sill.
190
AXLES
SUSPENSION
STEERING
To Next Page
Loading...
