73
ENGINE
SPECIAL FEATURES - CYLINDER HEAD TIGHTENING
Petrol engines
B1DP05BC
Cleaning to be carried out just prior to refitting.
WARNING: Clean the contact faces with the approved CITROËN cleaning product.
Do not use abrasives or cutting tools on the contact faces.
The contact faces must not bear any traces of impact or scratching.
Insert a tap in the threads of the holes in the cylinder block receiving the cylinder head bolts.
Brush the threads of the cylinder head bolts.
Oil the threads and under the heads of the bolts, using MOLYKOTE G RAPID PLUS.
Engines
Tightening Cylinder head bolts
(m.daN) (Max. reusable length in mm)
HFX - KFV
Tightening 2 ± 0,2
Angular tightening 140° ± 5°
175,5
NFU
Tightening 2 ± 0,2
Angular tightening 140° ± 5°
122
Pre-tightening 1,5 ± 0,2
KFU Tightening 2,5 ± 0,2 119
Angular tightening 200° ± 5°
NOTE: Tightening of the cylinder head after a repair is prohibited.
To Next Page
Loading...
