CHECKS: LOW PRESSURE FUEL SUPPLY CIRCUIT
Tools.
[1] Ø 10 mm low pressure connector : 4215-T
[2] Pressure gauge for testing boost pressure : 4073-T.A Toolkit 4073-T
IMPERATIVE: Respect the safety and cleanliness specific to high pressure diesel injection
engines.
Remove the air filter duct.
Link tool [1] in series, downstream of the injectors, between the fuel high pressure pump and the fuel
filter at «a» and «b».
WARNING: Any checking of pressure downstream of the fuel filter is prohibited.
Switch on the ignition.
ESSENTIAL: Check that the tool [2] is clean.
Check the negative pressure according to the table below:
Vacuum Observations
10 ± 05 cmhg Engine driven by the starter motor
20 ± 20 cmhg Engine running under full load
60 ± 05 cmhg Supply circuit obstructed
(full tank strainer, piping, fuel filter)
B1BP2PHC
Engine: DV4ATED4
C3
136
INJECTION
To Next Page
Loading...
