CITROEN C2 - ACCESS; ANTI-THEFT AND ANTI-INTRUSION PROTECTION

66
ENGINE
SPECIAL FEATURES - TIGHTENING TORQUES (m.daN)
Cylinder block
Crankshaft bearing cap cover
Tightening Method:
Pre-tighten the 10 screws (17) (from 1 to 10) to 1
Pre-tighten the 14 screws (19) (from 11 to 24) to 0,6
Tighten the 2 screws (18)
(inside the flywheel bell housing) to 0,8
Slacken the screws (17) by 180°
Tighten the 10 screws (17) (from 1 to 10) to 3
Tighten the screws (17) (from 1 to 10) by 140°
Tighten the 14 screws (19) (from 11 to 24) to 0,8
Engine: 9HX
B1DP1LLD
Sequence for tightening the screws (17), (18) and (19)
(17) Bearing cap fixing screws
(screws M9)
(18) Crankshaft bearing cap cover screws (screws M6)
(19) Crankshaft bearing cap cover screws (screws M6)
Angl.-t1-page037-91-2005 9/01/06 9:14 Page 66